Whirlpool Washer Error Code F5 E2: Door Lock Fault
The washer displays the F5 E2 error code, indicating a problem with the door lock mechanism. This typically occurs when the door lock is unable to engage or disengage properly, preventing the washer from operating.
Door Lock Assembly
Factory OEM Part #: W10619844
Door Lock Switch (OEM #W10619845)
Multimeter Resistance & Harness Pinout Specs
Unplug Power Before ProbingStep-by-Step Disassembly & OEM Part Replacement
Unplug & Access Panel
Disconnect the washer from the power source and remove the access panel to reach the door lock assembly.
Locate Component
Find the door lock assembly, typically located near the door hinge.
Multimeter Ohm/Voltage Check
Using a multimeter, check the resistance across the door lock assembly terminals; it should read between 500-1000 Ohms.
Swap New OEM Part
If the resistance is out of spec, replace the door lock assembly with the new OEM part.
Frequently Asked Questions (Whirlpool Code F5 E2)
How do I reset the F5 E2 error code?
To reset the error code, unplug the washer for 5 minutes, then plug it back in and try to start a cycle.
What should I do if the door lock assembly is not the issue?
If the door lock assembly is functioning correctly, check the wiring harness for damage or loose connections.
Shows panel removal, multimeter Ohm test, and OEM #W10619844 replacement.
Order Both Culprit Parts Together
Technicians recommend inspecting both #W10619844 and #W10619845 while the appliance panel is open:
Check #W10619844 In-Stock →