Samsung Washer Error Code 4C: Water Supply Issue
The washer displays error code 4C when it detects insufficient water supply during the fill cycle. This can be caused by clogged inlet filters, kinked hoses, or faulty water valves.
Water Inlet Valve Assembly
Factory OEM Part #: DC62-00180A
Water Supply Hose (OEM #DC97-16350A)
Multimeter Resistance & Harness Pinout Specs
Unplug Power Before ProbingStep-by-Step Disassembly & OEM Part Replacement
Unplug & Access Panel
Disconnect the washer from power and remove the back access panel to reach the water inlet valve.
Locate Component
Find the water inlet valve assembly, typically located near the back of the washer where the water supply hoses connect.
Multimeter Ohm/Voltage Check
Set the multimeter to the ohms setting and check the resistance across the inlet valve terminals; it should read between 3-5 Ohms.
Swap New OEM Part
If the resistance is out of spec, replace the water inlet valve with the new OEM part and reassemble the washer.
Frequently Asked Questions (Samsung Code 4C)
How do I reset the 4C error code?
To reset the error code, unplug the washer for 5 minutes, then plug it back in and restart the cycle.
What should I check if the error persists?
If the error persists, check the water supply hoses for kinks and ensure the inlet filters are clean.
Shows panel removal, multimeter Ohm test, and OEM #DC62-00180A replacement.
Order Both Culprit Parts Together
Technicians recommend inspecting both #DC62-00180A and #DC97-16350A while the appliance panel is open:
Check #DC62-00180A In-Stock →