Maytag Washer Error Code F7 E1: Motor Control Fault
The washer displays the F7 E1 error code, indicating a communication issue between the control board and the motor control unit. This can result in the washer failing to start or operate properly due to a faulty connection or defective components.
Motor Control Board
Factory OEM Part #: W10712395
Wire Harness (OEM #W10712394)
Multimeter Resistance & Harness Pinout Specs
Unplug Power Before ProbingStep-by-Step Disassembly & OEM Part Replacement
Unplug & Access Panel
Disconnect the washer from the power supply and remove the back access panel to reach the motor control board.
Locate Component
Identify the motor control board, typically located near the bottom of the washer, connected to the motor.
Multimeter Ohm/Voltage Check
Using a multimeter, check the resistance across the motor control board pins to ensure it falls within the expected range.
Swap New OEM Part
If the resistance is out of spec, replace the motor control board with the new OEM part and reassemble the washer.
Frequently Asked Questions (Maytag Code F7 E1)
How do I reset the F7 E1 error code?
To reset the F7 E1 error code, unplug the washer for 5 minutes, then plug it back in and attempt to start a cycle.
What should I do if the error code persists?
If the error code persists after resetting, inspect the wiring harness for damage and consider replacing the motor control board.
Shows panel removal, multimeter Ohm test, and OEM #W10712395 replacement.
Order Both Culprit Parts Together
Technicians recommend inspecting both #W10712395 and #W10712394 while the appliance panel is open:
Check #W10712395 In-Stock →