LG Washer Error Code OE: Drain Pump Failure
The OE error code indicates that the washer is unable to drain water properly, often due to a blockage or failure in the drain pump. This can lead to water pooling inside the drum and prevent the cycle from completing.
Drain Pump Assembly
Factory OEM Part #: 4681EA2001T
Drain Hose (OEM #5215FR2006L)
Multimeter Resistance & Harness Pinout Specs
Unplug Power Before ProbingStep-by-Step Disassembly & OEM Part Replacement
Unplug & Access Panel
Disconnect the washer from the power outlet and remove the back or front access panel to reach the drain pump.
Locate Component
Find the drain pump assembly, typically located at the bottom of the washer near the drain hose.
Multimeter Ohm/Voltage Check
Use a multimeter to check the resistance across the pump terminals; it should read between 10-15 Ohms.
Swap New OEM Part
If the pump is faulty, replace it with the new OEM drain pump assembly and reassemble the washer.
Frequently Asked Questions (LG Code OE)
How do I reset the OE error code?
To reset the OE error code, unplug the washer for 5 minutes, then plug it back in and run a drain cycle.
What should I check if the OE error persists?
If the error persists, check for clogs in the drain hose or filter, and ensure the drain pump is functioning properly.
Shows panel removal, multimeter Ohm test, and OEM #4681EA2001T replacement.
Order Both Culprit Parts Together
Technicians recommend inspecting both #4681EA2001T and #5215FR2006L while the appliance panel is open:
Check #4681EA2001T In-Stock →