KitchenAid Dishwasher Error Code F2 E2: Drain Pump Failure
The dishwasher displays the F2 E2 error code, indicating a drain pump failure. This typically occurs when the drain pump is unable to remove water from the tub, leading to potential flooding or improper cleaning.
Drain Pump Assembly
Factory OEM Part #: W10882880
Drain Pump Motor (OEM #W10882881)
Multimeter Resistance & Harness Pinout Specs
Unplug Power Before ProbingStep-by-Step Disassembly & OEM Part Replacement
Unplug & Access Panel
Disconnect the dishwasher from power and remove the lower access panel to reach the drain pump.
Locate Component
Find the drain pump assembly located at the bottom of the dishwasher.
Multimeter Ohm/Voltage Check
Use a multimeter to check the resistance across the drain pump terminals; it should read between 10-15 Ohms.
Swap New OEM Part
If the resistance is out of spec, replace the drain pump assembly with the new OEM part.
Frequently Asked Questions (KitchenAid Code F2 E2)
How do I reset the F2 E2 error code?
To reset the error code, unplug the dishwasher for 5 minutes, then plug it back in and run a cycle.
What should I do if the drain pump is not working?
Check the wiring and connections to the drain pump, and replace the pump if it shows resistance outside the expected range.
Shows panel removal, multimeter Ohm test, and OEM #W10882880 replacement.
Order Both Culprit Parts Together
Technicians recommend inspecting both #W10882880 and #W10882881 while the appliance panel is open:
Check #W10882880 In-Stock →