GE Dishwasher Error Code FTD: Faulty Drain Pump Detection
The dishwasher displays an FTD error code indicating a failure to drain water properly. This is typically caused by a malfunctioning drain pump or a blockage in the drain system.
Drain Pump Assembly
Factory OEM Part #: WD19X10018
Drain Pump Motor (OEM #WD19X10020)
Multimeter Resistance & Harness Pinout Specs
Unplug Power Before ProbingStep-by-Step Disassembly & OEM Part Replacement
Unplug & Access Panel
Disconnect the dishwasher from power and remove the lower access panel to reach the drain pump.
Locate Component
Find the drain pump assembly, typically located at the bottom of the dishwasher.
Multimeter Ohm/Voltage Check
Set the multimeter to measure resistance and check the drain pump terminals for expected resistance of 10-15 Ohms.
Swap New OEM Part
If the resistance is out of spec, replace the drain pump assembly with the new OEM part.
Frequently Asked Questions (GE Code FTD)
How do I reset the FTD error code?
To reset the FTD error code, unplug the dishwasher for 5 minutes and then plug it back in.
What should I check if the FTD error persists?
If the error persists, check for clogs in the drain hose and ensure the drain pump is functioning properly.
Shows panel removal, multimeter Ohm test, and OEM #WD19X10018 replacement.
Order Both Culprit Parts Together
Technicians recommend inspecting both #WD19X10018 and #WD19X10020 while the appliance panel is open:
Check #WD19X10018 In-Stock →